Telehandler Training Courses Kamloops

Telehandler Training Courses Kamloops - Employers are responsible for making certain that their supervisory and operating personnel are trained to work proficiently with telehandler machinery. The skill level of employees have to be assessed. If deficiencies are found, employers have to provide training so that employees attain the necessary level of ability. The level of responsibility of the individual must be taken into consideration when training is offered. Effective training will remedy any deficiencies in the understanding, knowledge and skills of telehandler operators and supervisors. Training may be undertaken through in-house session or by engaging the services of an external training provider. An assessment upon finishing the training period would determine whether or not the learning objectives have been met.

Regulations and guidelines for the basic telehandler operator testing and training are set by federal, state/provincial and local regulators. Basic training does not address such subject matters as the lifting of suspended loads, the lifting of persons, the use of rotating machinery or utilizing other attachments. Further training should be undertaken if such tasks are needed on the work place.

Maintenance and Inspection
Like whatever machinery, a telehandler requires effective maintenance. The machinery inevitably will suffer wear sooner or later. Proper maintenance is essential to ensuring safe operation of the telehandler machine. Checks and inspections are important to ongoing maintenance procedures. Operators should have machine-specific training to be able to monitor, prevent and rectify problems connected with deterioration, damage and wear. Personnel need competence and experience in both breakdown and periodic maintenance. The preventive maintenance instructions of the manufacturer should be seriously viewed and complied with, taking into account such factors as frequency of use and environmental conditions in the work setting.

The user of the machinery along with the owner of the machine share the responsibility for making sure that the telehandler is in full working condition. Pre-use inspections are typically done by the user, while general maintenance is normally carried out by the telehandler owner.

Click to Download the pdf